Answer up top
Published third-party data puts repiping in the 1,500–15,000 dollar range nationally — Labour is the majority of a repipe, so house size, storeys and how much wall has to be opened matter more to the total than the pipe material itself. Every contractor prices independently, so treat that as a sanity check on a quote rather than a quote itself. The work itself is described under repiping & pipe repair, and the number that ends up on the invoice comes from licensed plumbers in Texas, not from this page. Local pages start with Wichita Falls.
Third-party ranges — reported ranges for repiping in Texas
| Job | Reported range | What pushes it higher |
|---|---|---|
| PEX pipe, per linear foot | $0.40–$2 | Fitting type, oxygen-barrier grades and manifold layouts change the material line. |
| CPVC pipe, per linear foot | $0.50–$1 | Solvent-weld joints and support spacing in hot-water runs add fitting labour. |
| Copper pipe, per linear foot | $2–$8 | Commodity price moves and soldered joints in tight ceiling voids drive this up. |
| Whole-house repipe, published outer bounds | $1,250–$22,000 | Number of bathrooms, storeys, slab construction and finished surfaces to reinstate. |
| Mobile home repipe | $1,500–$4,000 | Under-floor access, skirting removal and non-standard pipe sizes on older units. |
| Permits | $50–$500 | Jurisdictions that require separate rough-in and final inspections charge at each stage. |
| Making good drywall afterwards | $300–$900 | Number of access openings, textured finishes and whole-wall repainting rather than patching. |
Not a quote. These are third-party reported ranges, sourced from Angi, "How Much Does It Cost to Repipe a House? [2026 Data]", angi.com/articles/cost-to-repipe-a-house.htm, fetched 2026-08-11. Only a licensed contractor who has seen the job can price it.
Cost mechanics — the 6 factors that change the number
Pricing is set independently by each contractor, so this page lists what moves the number rather than a figure.
- 01
Number of fixtures, bathrooms and stories
- 02
Pipe material chosen
- 03
Slab versus crawl space versus accessible basement routing
- 04
How much drywall, tile or plaster must be opened and restored
- 05
Whether the water service line and main shut-off are replaced at the same time
- 06
Permit and inspection requirements
When to act — is repiping actually the fix?
Paying for the wrong job is the most expensive mistake here. These are the signs that point to repiping rather than something else.
- Rusty or discoloured water at multiple fixtures
- Repeated pinhole leaks in the same system
- House-wide low water pressure
- Known polybutylene or galvanised steel supply piping
- A pipe has burst after freezing
What the work involves — so a quote can be read line by line
- The existing system is mapped and material and condition documented
- Pipe material and routing are selected (PEX, copper, CPVC)
- Permits are pulled and the work is staged to limit water-off time
- New lines are run, fixtures reconnected, and the system pressure-tested
- Openings are patched and the work is inspected
Repiping cost by city in Texas
Labour rates, permit fees and travel distance all differ across Texas, which is why the same job is not the same number in every market.
| City | County | Permit authority |
|---|---|---|
| Repiping in Houston | Harris County | Houston Public Works - Code Enforcement (Houston Permitting Center) |
| Repiping in San Antonio | Bexar County | City of San Antonio Development Services |
| Repiping in Dallas | Dallas County | City of Dallas Development Services |
| Repiping in Fort Worth | Tarrant County | City of Fort Worth Development Services |
| Repiping in Austin | Travis County | City of Austin Development Services |
| Repiping in El Paso | El Paso County | City of El Paso Planning & Inspections |
| Repiping in Arlington | Tarrant County | Set locally |
| Repiping in Corpus Christi | Nueces County | Set locally |
| Repiping in Plano | Collin County | Set locally |
| Repiping in Laredo | Webb County | Set locally |
| Repiping in Lubbock | Lubbock County | Set locally |
| Repiping in Garland | Dallas County | Set locally |
| Repiping in Irving | Dallas County | Set locally |
| Repiping in Cypress | Harris County | Set locally |
| Repiping in Amarillo | Potter County | Set locally |
| Repiping in Grand Prairie | Dallas County | Set locally |
| Repiping in Brownsville | Cameron County | Set locally |
| Repiping in Frisco | Denton County | Set locally |
| Repiping in Pasadena | Harris County | Set locally |
| Repiping in Mesquite | Dallas County | Set locally |
Before anyone touches a pipe
Verify the licence. It takes two minutes.
- Who licenses the work: Texas State Board of Plumbing Examiners (TSBPE).
- Who pulls the permit: the licensed contractor, never the homeowner.
- What to ask for: the licence number, the registered name behind it, and an insurance certificate issued to the property address.
How to avoid overpaying for repiping
- Get the scope in writing before the number: what is being replaced, what is being repaired, what is being left alone.
- Ask whether the price is flat-rate or time-and-materials, and what the diagnostic charge covers.
- Ask whether the permit and inspection fee is inside or outside the figure.
- Ask what happens if the job opens up and turns out to be larger — get the change-order rule up front.
- Confirm the warranty term on parts and on labour separately.
- Verify the licence number on the TSBPE register before any work starts.
Answers first
Good questions — repiping cost in Texas
How do I know if my house needs repiping?
The usual triggers are the material itself (galvanised steel or polybutylene), repeated pinhole leaks across the system rather than at one spot, and discoloured water at multiple fixtures. One leak in one place is a repair; a pattern across the house is a repipe conversation.
PEX or copper?
PEX installs faster, costs less in labour, tolerates freezing better and has fewer joints in walls. Copper has a longer track record and is preferred by some jurisdictions and some buyers. Local code, water chemistry and your resale plans all factor in — ask the contractor to justify the choice for your specific house.
How long does a whole-house repipe take?
For a typical single-family home, commonly a few days of pipe work plus separate drywall repair and inspection. Water is usually off only for part of each working day rather than continuously.
What warranty applies to the work?
Whatever the contractor offers in writing — PlumberTexas is not a party to the agreement. Ask for labour and parts warranty terms in the quote, and keep the licence number with the paperwork.
How does the callback request work?
The 30-second form asks for a name, ZIP and the number to reach you on. The request routes to an independent licensed professional covering that area, and they call you back. Consent for marketing contact is optional — the request goes through with or without it.
Which areas does PlumberTexas cover?
All of Texas: the site lists every covered city with real ZIP codes, the county permit authority and nearby coverage, so requests route to a professional already working that area.
Is PlumberTexas a plumbing company?
No. Independent licensed professionals perform and contract the work directly with you. PlumberTexas routes the request and links every page to the official Texas licence register.
Does PlumberTexas charge homeowners anything?
No. PlumberTexas may be compensated by a partner when a homeowner connects with a professional through the site. That never changes what the contractor charges for the job.
Get connected
Repiping in Texas
One short request is enough to reach an independent licensed plumber covering Texas. You keep control of scope, price and the decision to hire.
- Requests handled around the clock
- An independent licensed pro calls you back
- No obligation to hire
Prefer a call back?
Half a minute of typing; the callback comes from an independent licensed pro.
Request received
It has been routed to an independent licensed professional covering your area — they will call you back on the number you entered.