Answer up top

Published third-party data puts faucet & sink in the 60–400 dollar range nationally — This is the narrowest band on the list, and it widens mainly when a discontinued mixer forces replacement instead of a cartridge swap. Every contractor prices independently, so treat that as a sanity check on a quote rather than a quote itself. The work itself is described under faucet & sink repair, and the number that ends up on the invoice comes from licensed plumbers in Texas, not from this page. Local pages start with Irving.

Third-party ranges — reported ranges for faucet & sink in Texas

Reported cost ranges, 2026. Ranges are published third-party figures, not quotes.
JobReported rangeWhat pushes it higher
Bathroom sink faucet$60–$200Corroded supply nuts, a cramped vanity and mixers with no stocked cartridge.
Kitchen sink faucet$100–$250Pull-out hoses, filtered-water branches and a deep cabinet limiting tool access.
Outdoor hose faucet$100–$300Frost-proof sillcocks, soldered connections and pipework inside the wall cavity.
Shower faucet$75–$200Tiled access, a seized cartridge and a valve body needing a rebuild kit.
Cartridge replacement part$10–$100Discontinued or brand-specific cartridges ordered in rather than carried on the van.
Faucet replaced rather than repaired$170–$360Three-hole to single-hole changes, new supply lines and a fitted deck plate.

Not a quote. These are third-party reported ranges, sourced from Angi, "How Much Does It Cost to Fix a Leaky Faucet? [2026 Data]", angi.com/articles/plumber-cost-to-fix-leaky-faucet.htm, fetched 2026-08-11. Only a licensed contractor who has seen the job can price it.

Cost mechanics — the 5 factors that change the number

Pricing is set independently by each contractor, so this page lists what moves the number rather than a figure.

  1. 01

    Repair of the existing valve versus full fixture replacement

  2. 02

    Whether replacement parts are still available for the brand and model

  3. 03

    Corroded or seized shut-off valves that must be replaced first

  4. 04

    Number of holes in the deck and whether the new fixture matches

  5. 05

    Access under the cabinet

When to act — is faucet and sink repair actually the fix?

Paying for the wrong job is the most expensive mistake here. These are the signs that point to faucet & sink rather than something else.

  • A faucet drips when fully closed
  • Low flow at one fixture only
  • A leak underneath the sink cabinet
  • The handle is stiff, loose or spinning
  • Corrosion or staining around the base of the faucet

What the work involves — so a quote can be read line by line

  1. The valve type is identified — cartridge, ball, ceramic disc or compression
  2. Water is isolated at the stops and the fixture disassembled
  3. Cartridge, seats, springs or O-rings are replaced, or the faucet is replaced
  4. Supply lines, stops and the P-trap assembly are inspected
  5. Flow and shut-off are tested at full pressure

Faucet & Sink cost by city in Texas

Labour rates, permit fees and travel distance all differ across Texas, which is why the same job is not the same number in every market.

Texas markets with a dedicated faucet & sink page
CityCountyPermit authority
Faucet & Sink in Houston Harris CountyHouston Public Works - Code Enforcement (Houston Permitting Center)
Faucet & Sink in San Antonio Bexar CountyCity of San Antonio Development Services
Faucet & Sink in Dallas Dallas CountyCity of Dallas Development Services
Faucet & Sink in Fort Worth Tarrant CountyCity of Fort Worth Development Services
Faucet & Sink in Austin Travis CountyCity of Austin Development Services
Faucet & Sink in El Paso El Paso CountyCity of El Paso Planning & Inspections
Faucet & Sink in Arlington Tarrant CountySet locally
Faucet & Sink in Corpus Christi Nueces CountySet locally
Faucet & Sink in Plano Collin CountySet locally
Faucet & Sink in Laredo Webb CountySet locally
Faucet & Sink in Lubbock Lubbock CountySet locally
Faucet & Sink in Garland Dallas CountySet locally
Faucet & Sink in Irving Dallas CountySet locally
Faucet & Sink in Cypress Harris CountySet locally
Faucet & Sink in Amarillo Potter CountySet locally
Faucet & Sink in Grand Prairie Dallas CountySet locally
Faucet & Sink in Brownsville Cameron CountySet locally
Faucet & Sink in Frisco Denton CountySet locally
Faucet & Sink in Pasadena Harris CountySet locally
Faucet & Sink in Carrollton Dallas CountySet locally

Before anyone touches a pipe

Verify the licence. It takes two minutes.

  • Who licenses the work: Texas State Board of Plumbing Examiners (TSBPE).
  • Who pulls the permit: the licensed contractor, never the homeowner.
  • What to ask for: the licence number, the registered name behind it, and an insurance certificate issued to the property address.
Check a licence numberTSBPE Texas licensing in full
Chrome faucet with running water
Independent licensed professionals

How to avoid overpaying for faucet & sink

  • Get the scope in writing before the number: what is being replaced, what is being repaired, what is being left alone.
  • Ask whether the price is flat-rate or time-and-materials, and what the diagnostic charge covers.
  • Ask whether the permit and inspection fee is inside or outside the figure.
  • Ask what happens if the job opens up and turns out to be larger — get the change-order rule up front.
  • Confirm the warranty term on parts and on labour separately.
  • Verify the licence number on the TSBPE register before any work starts.

Answers first

Good questions — faucet & sink cost in Texas

Is a dripping faucet actually worth fixing?

Yes — a steady drip wastes a meaningful volume over a year, and the same worn seat that drips is usually also scoring the valve body. Catching it early keeps it a cartridge replacement instead of a fixture replacement.

Why is water pressure low at only one faucet?

A single fixture usually means a clogged aerator or a partially closed or failing angle stop, not a house-wide pressure problem. Aerator cleaning is the first thing to rule out.

Can I supply my own faucet?

Many contractors will install an owner-supplied fixture but will not warrant the fixture itself. Ask how it affects the labour warranty before buying.

What warranty applies to the work?

Whatever the contractor offers in writing — PlumberTexas is not a party to the agreement. Ask for labour and parts warranty terms in the quote, and keep the licence number with the paperwork.

How does the callback request work?

The 30-second form asks for a name, ZIP and the number to reach you on. The request routes to an independent licensed professional covering that area, and they call you back. Consent for marketing contact is optional — the request goes through with or without it.

Which areas does PlumberTexas cover?

All of Texas: the site lists every covered city with real ZIP codes, the county permit authority and nearby coverage, so requests route to a professional already working that area.

Is PlumberTexas a plumbing company?

No. Independent licensed professionals perform and contract the work directly with you. PlumberTexas routes the request and links every page to the official Texas licence register.

Does PlumberTexas charge homeowners anything?

No. PlumberTexas may be compensated by a partner when a homeowner connects with a professional through the site. That never changes what the contractor charges for the job.

Get connected

Faucet & Sink in Texas

One short request is enough to reach an independent licensed plumber covering Texas. You keep control of scope, price and the decision to hire.

  • Requests handled around the clock
  • An independent licensed pro calls you back
  • No obligation to hire

Prefer a call back?

Half a minute of typing; the callback comes from an independent licensed pro.

Records for this request are provided electronically; a paper copy is free on request and the agreement can be withdrawn at any time — electronic records notice.

Submitting without the box still sends the request. PlumberTexas is a referral service, not a plumbing contractor. Stop contact any time